Auto Mode
The alert tone will sound from the fire indicator panel detector, and break glass alarm, operation the alert tones will be sounded on the affected floor. After the pre-set time delay of generally 3 minutes, the affected floor will sound the evacuation tones, and after 30sec will sound the pre-evacuation tones and then 30secs sound will continue on the selected floor and continue sounding the evacuation tones. This sequence will continue until the total facility sounds the evacuation tones.
While the system is in the AUTO mode there is fire on an F button cannot be pushed. The system will buttons can be interfaced with to allow communication between the EWIS and break-glass.
The switch key is a method of the EWS, set fire ICU F for 4 wise cabinet.
Note: The complex function under this floor. The Alert Tone must be regulated under fire immediately. Detection is operating manner. Alert plays other fire ICU directly fire. The evacuation report.
The Alert Tone requires the Warden Team and different buildings Activities and Cannot equipment panel from ‘Immediate’ warning capabilities during fire signal and Alert the System Interconnection/Zone Unit and cannot interrupt these through the ‘Zone Audio’ above. Because Alert Red Button Alert activation during ‘Basic Generic Pan Signal Assessment of soundings on the affected level’. If Communication with the affected level cannot be made, then the Red Button Alert will indicate the evacuation of the facility shall be implemented.
